Step 1:     Flip out the panel surrounding the heather controls. Use a flat bending tool. Start on the right side of the panel. Unclip just so much that you can access the screws behind.

Step 2:     Remove the 2 screws to the right side of the heater controls .If a higher position is preferred, you can use the 2 screws to the right side of the radio location.

Step 3:     Install the Dash Mount on these 2 screw and push the Dash Mount as much as possible against the console wall. Tighten properly.

Step 4:     Push the panel back into position.

Dashmount will not be liable for any damage caused to a vehicle in executing the fitting of the bracket