Step 1:     Remove the Torx 20 screw beneath the ashtray housing.

Step 2:    Pull the assembly downwards and set aside.

Step 3:    Remove the two Torx 20 screws beneath the heater control panel.

Step 4:    Unclip the fascia panel (there are three clips along the upper ledge, the centre one of which, may require easing with a bending tool).

Step 5:    Hook the bracket behind the left edge of the recess adhering the double sided tape to the console edge.

Step 6:    Refit the trim.

Bracket squared off to allow panel to seat due to modified console edge

Dashmount will not be liable for any damage caused to a vehicle in executing the fitting of the bracket