Step 1: Begin by removing cupholder from centre console. This simply pulls up. Remove the two phillips screws.Open centre console and remove bottom tray. Remove the phillips screws and set aside. Pull centre console back. This will expose two screws at the back of the trim bezel that surrounds the shifter knob. Remove these screws.

Step 2: Next, Work bezel up starting with the left side and work forward. This bezel is held by clips.Use a flat bending tool to remove the upper part of the trim bezel. Remove the 8mm bolt to the right of the radio.

Step 3: Position the Dash Mount over this hole and replace the factory bolt. Reassemble the bezel in reverse order.

Dashmount will not be liable for any damage caused to a vehicle in executing the fitting of the bracket