70502 - Mitsubishi Diamante '97- 02

Step 1: Begin by removing the trim bezel surrounding the shifter knob. Start by removing the cup holder in front of the shifter. This pulls out. Remove the holder behind the shifter knob. This just pulls out. Start at the rear of the bezel and unclip working your way forward.

Step 2: Disconnect the wiring from the back side of the bezel and let bezel hang to the left. In the upper right corner of the shifter knob is a phillips screw. Remove this screw and position the Dash Mount over this hole. Replace the factory screw and tighten.

Step 3: Reassemble the console trim bezel in reverse order. Do not forget to reconnect all wiring.

Dashmount will not be liable for any damage caused to a vehicle in executing the fitting of the bracket