1. Remove the radio with the appropriate radio tools and disconnect if you
know the code. Set aside otherwise, but protect the fascia.

2. Remove the two phillips screws in the radio recess.

3. Remove the two upper switch assemblies by unclipping. remove the screw
beneath.

4. Unclip the fascia panel at the upper edge, and lever forwards some 4-5cm.

5. Locate the bracket over the upper edge of the air vent housing right or
left according to taste.

6. Locate the bracket and refit the fascia, switches screws and radio.


NB If the fascia panel requires complete removal for the application of a an
interface cable, then unclip the gear lever trim and the two phillips
screws at the base of the console panel. These are slightly hidden and
will need locating with a torch.

Dashmount will not be liable for any damage caused to a vehicle in executing the fitting of the bracket