Step 1:Unscrew the Phillips head screw inside each spy ball vent: align the channel in the base of the vent to access. You do not have to remove the screw, merely release it and leave it in the channel.

Step 2:Unclip the fascia panel, at each corner of the base and then on each side, and lastly by pulling away from the clock area.

Step 3:Locate the bracket with the lower left Torx screw securing the audio unit using an offset screwdriver.

Step 4:Refit the fascia panel around the bracket and secure the vents. Twist the plate inwards to facilitate if required.

NB To enable easier fitting of the fascia panel, disconnect the clock and heater feeds.

Dashmount will not be liable for any damage caused to a vehicle in executing the fitting of the bracket